Bernina Kaffe 770 QE PLUS - Adjusting the Maximum Embroidering Speed; Centering or Opening Embroidery Motifs in the Original Position; Calibrating the Embroidery Hoop

Setup Program
54
Adjusting the maximum embroidering speed
You can use this function to reduce the maximum speed.
> Tap «Setup Program».
> Tap «Embroidery settings».
RPM
> Tap «Maximum Embroidery Speed».
> Set the maximum sewing speed.
Centering or opening embroidery motifs in the original position
When opening the embroidery motifs on the machine, they are always centered in the Embroidery Hoop. If it
is desired to open embroidery motifs in the original position (determined by the BERNINA Embroidery
Software), the function «Centering the embroidery motif» must be activated.
> Tap «Setup Program».
> Tap «Embroidery settings».
> Tap «Centering the embroidery motif».
> Tap the Switch.
– A previously moved embroidery motif which has been saved in the new position is opened in the
saved position after selecting.
> Tap the Switch again.
– The embroidery motif is centered to the Embroidery Hoop.
Calibrating the embroidery hoop
The calibration of the embroidery hoop is the coordination of the needle to the center of the embroidery
hoop.
Prerequisite:
• The Embroidery Module is connected and the embroidery hoop with the appropriate embroidery
template is attached.
> Tap «Setup Program».
> Tap «Embroidery settings».