Bernina Kaffe 770 QE PLUS - Administering Embroidery Motifs; Saving Embroidery Motifs in the Personal Memory

Creative embroidering
165
The mobility of the embroidery arm can be restricted or impeded with very narrow fabric tubes. Therefore
make sure that the embroidery hoop can move forwards and backwards sufficiently. An impediment of the
embroidery arm caused by a fabric tube which is too tight can result in embroidery motif offset or damage to
the fabric.
Check the movability of the freearm
Note: If the fabric tube is narrow, deactivate the Thread Away Mode in the Setup Program.
> Open the embroidery motif on the machine and edit as desired.
> Mark the embroidery motif position and the size on the fabric in a suitable way.
> Select the embroidery hoop as small as possible.
> Hoop or stick the fabric along with the appropriate stabilizer in the embroidery hoop, depending on the
stabilizer.
> Pull the fabric tube carefully over the freearm of the machine and attach the embroidery hoop at the
clutch of the embroidery module.
> If necessary, reposition the embroidery motif.
check
> Tap «Check Embroidery Motif Size».
> After the successful check of the embroidery motif size, start the embroidery process.
15.12 Administering embroidery motifs
Administering embroidery motifs
4
3
1
2
1 «Load Embroidery Motif» 3 «Save Embroidery Motif»
2 «Add Embroidery Motif» 4 «Delete Embroidery Motif»
Saving embroidery motifs in the personal memory
In the file «Save Embroidery Motifs» any embroidery motifs including individually edited embroidery motifs
can be saved.
> Select an embroidery motif.
> Edit the embroidery motif.
> Tap «Selection».
> Tap «Save Embroidery Motif».
– The embroidery motif to be saved is outlined in yellow.
– The «Embroidery machine» is activated.
> Tap «Confirm».