Beumer stretch hood S - Page 77

BEUMER stretch hood® S
Operation
BA-6090103-EN
19.08.09
77
Parameters Function Note
070 Stretch carriages, stretch
position 1
This parameter defines the position of
the stretch carriages for pulling the film
hood over the package. Set the value
so as to prevent the crimping bows
from touching the package when they
are lowered.
072 Stretch sleds, stretch
position 1
This parameter defines the position of
the stretch sleds for pulling the film
hood over the package. Set the value
so as to prevent the crimping bows
from touching the package when they
are lowered.
074 Stretch carriages, stretch
position 2
The stretch carriages are moved to the
second stretch position while the film
hood is being pulled over the package.
Set the value so as to prevent the
crimping bows from touching the pack-
age or the pallet when they are low-
ered.
076 Stretch sleds, stretch
position 2
The stretch sleds are moved to the
second stretch position while the film
hood is being pulled over the package.
Set the value so as to prevent the
crimping bows from touching the pack-
age or the pallet when they are low-
ered.
080 Hoist carts - crimp film This parameter defines the position of
the hoist carts for crimping the film.
082 Hoist carts, stretch posi-
tion 2
The hoist carts are moved to the sec-
ond stretch position while the film hood
is being pulled over the package. The
parameter determines the starting posi-
tion of this function depending on the
package height.
084 Move back crimping mo-
tors at top edge of pack-
age
This parameter defines the position
where the crimping motors move back
for releasing the film. This position
depends on the package height. When
entering the value "0", the crimping
motors move back directly at the level
of the top edge of the package. If a
greater value is entered, the crimping
motors move back at a lower level.
086 Speed of hoist carts in
the area of the package
top
This parameter defines the speed of
the hoist carts in the upper area of the
package.