Beumer stretch hood S - Page 78

Operation
BEUMER stretch hood® S
78 BA-6090103-EN
19.08.09
Parameters Function Note
088 Limit between package
top and package centre
The parameter defines the limit be-
tween package top and package cen-
tre. This limit is required for changing
the speed.
090 Speed of hoist carts in
the area of the package
centre
This parameter defines the speed of
the hoist carts in the central area of the
package.
092 Total film length The total film length is displayed in this
parameter. The value can be modified
when the cursor is moved onto the
field.
098 Advance crimping motors
at package base
This parameter defines the position
where the crimping motors advance for
clamping the film for the understretch.
102 Speed of hoist carts in
the area of the package
base
This parameter defines the speed of
the hoist carts in the lower area of the
package.
104 Limit between package
centre and package base
The parameter defines the limit be-
tween package centre and package
base. This limit is required for changing
the speed.
106 Move crimping bows
under package
This parameter defines the position
where the crimping bows are moved
under the pallet to form the under-
stretch.
108 Stretch carriages - posi-
tion below pallet
This parameter defines the position
where the crimping bows are moved
under the pallet to form the under-
stretch.
112 Length of sleeve The parameter value presets the length
of the sleeve.
114 Maximum package
height
The parameter defines the maximum
package height to be stretched. If the
package height exceeds this value, the
package is not stretched but trans-
ferred to the subsequent conveyor.
116 Minimum package height The parameter defines the minimum
package height to be stretched. If the
package height falls below this value,
the package is not stretched but trans-
ferred to the subsequent conveyor.