Electric Actuator ICON2000/ICON2000AD
ADDENDUM A to INSTRUCTION HANDBOOK MAN 618
© Copyright by BIFFI Italia. All right reserved. Page
1 SAFETY INSTRUCTIONS
1.1 General
This ADDENDUM A is an integration to INSTRUCTION
HANDBOOK MAN 618 to prescribes the Safety Instructions applicable
to all the electric actuators Series ICON2000/ICON2000AD either as a
base unit either when they are equipped with an optional extension [A]
for additional entry mounted on the control compartment or when they
are equipped with an optional extension [B] with additional entries or
with an optional extension [C] with optional electronic card both
mounted on the terminal board compartment, as identified by the
pictures here below, when they are installed in Hazardous Areas as
defined by the IEC/EN 60079-10-1 IEC/EN 60079-10-2.
Under the same conditions, the optional extensions [A], [B] or [C], can
be mounted on a base unit ICON2000/ICON2000AD already installed
on field.
It is assumed that the installation, the setting, the
commissioning, the maintenance and repair works are
carried out by qualified personnel and checked by
responsible Specialists.
Both the base unit ICON2000/ICON2000AD and optional extension are
designed in accordance with the applicable International Rules and
Specifications but in any case the following Regulation must be observed:
the general installation and safety regulations
the proper use of personal protective devices (glasses, clothing, gloves,)
the proper use of tools, lifting and transport equipment.
To Next Page
