BIFFI ICON 2000 - Page 249

“ICON 2000v4"
instruction and operating manual
© Copyright by BIFFI Italia. All right reserved. Section 618/42 Page 18
Contents may change without notice
Octet 3 bit0
reserved
Diag.Ext_Diag_Overflow (1)= Slave has more diagnosis data than fit into the
buffer
Octet 4 bit0
Diag_Master_Add Address of the master that has parameterized the
salve. 0xFF when slave not parameterized yet
Octet 5 bit0
Ident_Number High byte of the slave’s ident number.
ICON2000v4_DPV1 report 0x09
Octet 6 bit0
Ident_Number Low byte of the slave’s ident number.
ICON2000v4_DPV1 report 0x37
Identifier Related Diagnosis block
Octet 7 bit0
0
1
Header: ICON2000v4_DPV1 report 0x42
Block_Length Number of octets of this block including this header
Selection (01)= Identifier Related Diagnostic
Octet 8 bit0
0
0
0
0
Identifier_Diagnosis_Data_Array
Identifier_Diagnosis_Entry_1 (0)= Module 1 has no diagnosis data
(1)= Module 1 has diagnosis data
Identifier_Diagnosis_Entry_2 (0)= Module 2 has no diagnosis data
(1)= Module 2 has diagnosis data
Identifier_Diagnosis_Entry_3 (0)= Module 3 has no diagnosis data
(1)= Module 3 has diagnosis data
Identifier_Diagnosis_Entry_4 (0)= Module 4 has no diagnosis data
(1)= Module 4 has diagnosis data d
padding bits
Device Related Diagnosis block
Octet 9 bit0
0
0
Header: ICON2000v4_DPV1 report 0x06
Block_Length Number of octets of this block including this header
Selection (00)= Device Related Diagnostic
Octet 10 bit0
1
0
0
0
0
0
0
1
Status: ICON2000v4_DPV1 report 0x81
Status_Type (1)= Status_Message
Identifier (1)= Status
Octet 11 bit0
0
0
0
0
0
0
0
0
Slot_Number: ICON2000v4_DPV1 report 0x00
Octet 12 bit0
0
0
0
0
0
0
0
0
Status_Specifier: ICON2000v4_DPV1 report 0x00