SECTION 2 INSTALLATION AND PREPARATION FOR USE
______________________________________________________________________
2-7
2.3.1 BIS VISTA Monitor
2.3.1.1 Front Panel
The front panel of the BIS VISTA monitor contains the Touch Screen, BISx port and the
ON/Standby button. See Figure 3.
2.3.1.2 Touch Screen
The BIS VISTA monitor is designed so that all controls (with the exception of the
ON/Standby button) are accessible by touching a designated area on the monitor screen.
This area is called a touch key. The touch keys are designed to function even when the user
is wearing examination gloves.
2.3.1.3 ON/Standby button
The ON/Standby button is located in the lower right corner of the monitor and indicates
whether the monitor is ON or in Standby mode. When the small LED light to the right of
the ON/Standby button is green, the unit is running and providing power to the BISx.
When it is yellow, the battery is charging and the system is in Standby mode. When it is not
lit, no A/C power is available to the unit; pressing the ON/Standby button will start up the
monitor using the battery.
2.3.1.4 Rear Panel
The rear panel components are pictured in Figure 4. They include: two USB ports (Type A
and B), the clamp shoe, an RS-232 port, the Reset button, the Battery/Power Supply cover,
and the power cord receptacle.
To Next Page