SECTION 2 INSTALLATION AND PREPARATION FOR USE
______________________________________________________________________
2-13
2.6.1 Language Selection
The BIS VISTA monitor is designed to support multiple languages. If the screen does not
display the desired language, follow these steps:
To change the language:
1. Press [MENU].
2. Press [Next] to go to the second menu, then [Next] again to go to the third menu.
3. Press [Language]. The current language is displayed.
4. Use the [+] or [-] keys to scroll through the list of languages until the desired
language appears. All screens will now display in the selected language.
5. Press [HOME] to return to the main screen.
2.6.2 Date and Time
To set the current date and time:
1. Press [MENU].
2. Press [Next] to go to the second menu, then [Next] again to go to the third menu.
3. Press [Date and Time]. A new screen displays the current date and time. “Day” is
displayed in blue letters.
4. Use the up and down arrows to set the day of the month.
5. Press [Month]. “Month” is displayed in blue letters.
6. Use the up and down arrows to set the month.
7. Repeat this process for the “Year,” “Hour,” “Minute” and “Second” displays.
8. When you have finished, you may press [Return to Previous Menu] or press
[HOME] to return to the main screen.
Note:
The time/date is initially set for the Eastern Standard or Eastern Daylight Time zone (USA).
It will be necessary for you to change the time twice per year using the Time/Date feature if
you are located in a time zone that alters its clocks at the beginning or end of Daylight
Savings Time.
2.6.3 View/Save Settings
The BIS VISTA monitor will always start up configured to settings that have been saved in
memory.
To save the current configuration settings,
1. Press [MENU].
2. Press [View/Save Settings]. The current settings display.
3. Press [Save Active]. The message, “Settings Saved” appears. The settings displayed
will be saved except as noted below.
4. Press [Previous] or [HOME] to exit.
Notes:
The “Save Active” option is disabled when in Battery Backup-Low Power condition.
The following settings are not saved by the “Save Active” option: Impedance Checking
(always returns to ON), Filters (returns to ON), and Display Type (returns to BIS).
To Next Page
Loading...