SECTION 3 OPERATING THE BIS VISTA MONITORING SYSTEM
______________________________________________________________________
3-19
To view or save the current configuration settings, press [View/Save Settings]. The
current settings display on the screen. Settings that are active but have not been saved are
displayed in yellow.
Save Active: Press this touch key to save the settings on display (the “Active” Settings) to
the current Monitor Mode. The message, “Settings Saved” appears. The settings displayed
will be saved except as noted below:
Notes:
The “Save Active” option is disabled when in Battery Backup-Low Power
condition.
The following settings are not saved by the “Save Active” option: Impedance
Checking (always returns to ON), Filters (returns to ON), and Display Type
(returns to BIS).
Settings are set and saved for the current Monitor Mode only (See 3.5.10 “Monitor Mode”).
Restore Saved: Press this touch key to return the current settings to the previously saved
settings (the start-up settings). This applies to the current Monitor Mode only.
Restore Default: Press this touch key to restore the factory default settings. This applies to
the current Monitor Mode only. This restores the default values until the next time the
monitor is re-started. To permanently restore the default settings, press [Restore Default]
and then press [Save Active].
To restore the factory settings to all Monitor Modes, go to the Maintenance Menu and press
[Restore Default Settings for All Modes].
Press [Previous] or [HOME] to exit.
3.5.7 Help
To access Help, press [MENU].
Figure 19 - Help
The [Help] touch key allows the user access to information on use of the BIS VISTA
Monitoring System including: sensor placement, BIS guidelines, troubleshooting and system
features. Press the [Help] key, then follow the on-screen instructions.
To Next Page
Loading...