SECTION 3 OPERATING THE BIS VISTA MONITORING SYSTEM
______________________________________________________________________
3-14
2. To change the Target Range display format, press the [Target Range Format]
touch key. When the left side of the [Target Range Format] key is illuminated, the
Target Range will display as a colored band. When the right side of the [Target
Range Format] touch key is illuminated, the Target Range displays as a pair of
horizontal lines denoting the upper and lower limits.
3. To activate or deactivate the target alarm, press [Target Alarm].
• A green bell indicates that the Target Alarm is active. Alarms will sound when
the BIS value falls outside of the Target Range, unless the alarms have been
silenced on the main screen.
• A red bell with an ‘X’ indicates that the Target Alarm is inactive. Audible Target
Alarms will not sound.
4. The Target Range upper (High) and lower (Low) limits are displayed between minus
and plus signs. To change the Target Range, use the [+] and [-] touch keys to
increase or decrease the Target Range limits. Each key press will change the limit by
a factor of 5. The system will not allow the difference between the upper and lower
limits to be less than 5. A high value of 100 = none, and a low of 0 = none.
To permanently save this change, press the [View/Save Settings] touch key in the menu
system, then press [Save Active].
To Next Page
Loading...