EasyManuals Logo

Bizerba eS10 User Manual

Bizerba eS10
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
About the device Operating instructions eS10
12 38034911005 en
2
2.10 Regulations of approval for weighing data memory
The points listed below are prescribed by the EC type test certificate; these must be abso-
lutely observed by the user. The following conditions must be fulfilled in relation to the
long-term storage of weighing results:
Weighing results must be stored together with an identification, so that each weighing
process of each weighing result can be easily assigned and verified if this should be
necessary. These identifications must also be specified for documents that have been
created with additional devices.
If taring was performed, tare and gross values have to be stored.
Contracting parties must be able to verify the stored weighing results.
Business documents that are created by an additional device not subject to statutory met-
rological inspection in accordance with the preliminary comment to Appendix 1 of directive
2009/23/EC, must contain the following information:
Identification for each weighing conveyor.
When used in Germany, an additional note is required stating that, based on the iden-
tification information, the weighing results can be compared to the stored weighing re-
sults in compliance with the guidelines.
2.11 Operating conditions
Please contact us or our customer service departments if you have any doubts concerning
the practical application of these conditions.
Protection type, temperature and air humidity
The permitted values and the protection type can be found on the device identification
plate and in the Technical data.
Air convection
In order to prevent unacceptable heating, there must be free air convection around the de-
vice.
Supply voltage
The permitted values can be found on the device identification plate and in the Technical
data.
Written permission for changes
Modifications to the devices require our prior written consent.
Repairs on the device may only be performed by the manufacturer or
authorized specialist workshops.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bizerba eS10 and is the answer not in the manual?

Bizerba eS10 Specifications

General IconGeneral
BrandBizerba
ModeleS10
CategoryScales
LanguageEnglish

Related product manuals