Operating instructions eS10 About the device
38034911005 en 13
2
2.12 Software
The device has a software download.
A software must only be loaded if approved by the owner of the meas-
uring device.
2.13 Load receptor (optional)
Free-standing, unfixed and mobile scales are equipped with a level. After each change of
location check if the load receptor is horizontally aligned.
Load receptors may only be loaded up to the maximum approved load. The maximum load
can be found on the type plate of the load receptor.
2.14 Warranty
Installation, putting into operation as well as initial instruction regarding operation is carried
out by Bizerba Customer Service, Bizerba specialists or companies commissioned by Bi-
zerba.
Warranty for defects shall not exist in particular if and insofar as the defects occurred to
the delivered goods or to assets of the ordering party are attributable to the following rea-
sons:
– Non-observance of operating conditions
– Non-adherence to the technical documentation
– Defective electrical installation by the customer
– Structural modifications to the equipment
– Incorrect programming and operation
– Missing backup
– Natural wear and tear
– Wrong cleaning agent
The warranty will lapse if defects/damage that occur are caused by persons not authorized
by Bizerba. The warranty will lapse if any spare parts or operating material other than origi-
nal Bizerba ones are used. If you have any questions on warranty, spare parts or operat-
ing material, please contact your Bizerba consultant.
If you reset or program devices, check the new setting by means of a
test run and test printout. This helps to avoid incorrect results.
Check that the Bizerba products are handled correctly and repeat train-
ing if necessary.
To Next Page
Loading...
