Operating instructions eS10 Operation
38034911005 en 39
5
The charging time of an empty battery is about 11 hours. The battery pack discharges
even while not in use for a longer period of time if the scale is not connected to the power
supply. Therefore, connect the scale to the power supply whenever possible. An over-
charging of the battery pack is automatically prevented due to an integrated charging con-
nection. The charging connection prevents harmful deep discharge.
The accumulator's life span decreases if the accumulator is constantly
operated in run down condition. Recharge battery pack after each use.
In order to obtain a long battery pack operating time, the device is switched off under the
following conditions:
–
After pressing key
for about 3 s.
– Automatically after expiration of a specific time w/o operating and weighing functions.
The default setting is 15 minutes. The time can be changed in the service menu (gen-
eral parameters) step 04.
Press any key to switch the device on again.
Operation with power supply
Plug in power pack The scale is supplied via power supply, and the batteries are charged
at the same time. In case of a power failure the scale automatically switches to battery op-
eration. As soon as power is back on, the scale automatically switches back to power sup-
ply.
Symbol displays
Battery pack symbol Operating
mode
Explanation
off Operation with power supply
always on Operation with
battery pack
Charging of batteries is OK
slowly flashing battery charging about 50%
quickly flash-
ing
Battery pack must be charged. Depending on the
age of the battery pack, ambient temperature
and method of operation it is possible to continue
operations for about 10 - 60 minutes.
To Next Page
Loading...
