8–
1) LCD screen
This is a large liquid crystal display with 240 (V) × 320 (H) dots. It simultaneously displays traces (8 div
× 10 div), various setting values, measured values, etc.
2) Input connector
SMA (J) connector.
3) Input connector for DC power source
Connects AC adaptor BC2650.
4) RS-232C connector
Connects PC and printer, by using RS-232C cable.
5) Function keys (F1 to F6)
Functions change according to operation. Have functions corresponding to the on-screen displays.
6) Center frequency key
2650/2652
: Use this key to set the center frequency. It can set between 0 to 3.3GHz (100kHz step).
2658: Use this key to set the center frequency. It can set between 0 to 8.5GHz (100kHz step).
7) Frequency span key
2650/2652: Use this key to set the frequency span. It can set between 200kHz to 2GHz, ZERO SPAN
FULL SPAN (3.3GHz).
2658 Use this key to set the frequency span. It can set between 200kHz to 5GHz, ZERO SPAN
and FULL SPAN (8.5GHz).
8) Reference level key
Set the reference level, etc. Reference level can set between +10dBm and -60dBm (1dB step).
9) Resolution bandwidth key
Use this key to set the resolution bandwidth. It can set between 3kHz and 3MHz.
10) Video bandwidth key
Use this key to set the video bandwidth. It can set between 100Hz and 1MHz.
11) AUTO tuning key
Tune up to the maximum level in 3.3GHz(2650/2652)/8.5GHz(2658) zones, and display by the optimal
setup. This does not operate normally when the signal level is lower than -40dBm , or when the input
frequency is below 50MHz, or when the frequency span is ZERO SPAN or FULL SPAN.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
