9–
12) Measuring function key
Available for Channel power, Adjacent channel leakage power, Occupied frequency bandwidth, Electric
field strength and Magnetic field strength measurement (optional).
13) Calculation function key
Available for Max hold, Min hold, Average and Over write.
14) Display scale key
Use this key to select the display scale of amplitude axis from 2dB/div or 10dB/div.
15) Sweep key
Use this key to set the sweep time between 10ms to 30s or set the detection mode.
16) Hold/Run key
Stops or restarts the measurement.
17) Marker & Peak search key
Use this key to set and move a marker.
18) Save/Load key
Saves 100traces and 100setups, and loads 1trace and 1setup.
19) Print key
When pressing this key, the image is printed with a printer PT2650(optional) as it is.
20) RS-232C key
Sets baud rate and transfers a current or saved trace.
21) Display control key
Sets contrast, backlight ON/OFF, brightness of backlight, invert display and buzzer ON/OFF.
22) Rotary encoder
Use this to make various settings.
23) Power switch
Use this to turn the power ON or OFF.
To Next Page
Loading...
Need help?
General
