11
Getting Started with Videohub Routers
Network Preferences in Mac OS X set to “Using DHCP with
manual address” to provide a static IP address.
Network control panel in Windows set to “Use the following
IP address” to provide a static IP address.
Configuring your Videohub Server Settings
If you will be using Ethernet to connect to your Videohub, refer to the "Configuring Videohub with
Blackmagic Videohub Setup" section on the next page.
Videohubs without Ethernet are connected to a computer via USB and other control panels can see
the Videohub by looking for this computer. It effectively becomes a "server", that all the other control
panels on the network can connect to.
A Videohub "server" needs a static IP address and your network administrator will probably want to
configure this for you. Please follow the steps below for your respective operating system.
Mac OS X
Step 1. Go to System Preferences
Step 2. Click on Network
Step 3. Check the IP address in the configuration information for your Ethernet or Airport network.
Step 4. Set the network configuration to either Using DHCP with manual address or Manually.
Windows 7
Step 1. Open Control Panel
Step 2. Click on the Network and Sharing Center.
Step 3. Next to your connection, click Local Area Connection for Windows 7.
Step 4. Click on Properties and Select Internet Protocol Version 4 (TCP/IPv4).
Step 5. Click on Properties. Ensure "Use the following IP address" has been selected.
Windows 8
Step 1. From the desktop, hover over the right corner to bring up the charms bar.
Step 2. Click on Settings, then Control Panel.
Step 3. Click on the Network and Sharing Center.
Step 4. In the Network and Sharing Center, click on Change Adapter Settings on the left menu pane.
Step 5. Right click on your Ethernet connection and select Properties.
Step 6. Select Internet Protocol Version 4 (TCP/IPv4).
St ep 7. Click the Properties button. Ensure "Use the following IP address" has been selected.
To Next Page
Loading...
Need help?
General
