Böhnke + Partner bp308 - Page 131

| | |
| | +- Save parameters
| | |
| | +- Save factory default
| |
| +- Testing
| | |
| | +- UCM-Test (A3)
| | | * Code for Tests
| | | * UCM-test (A3) with doors open
| | | - off
| | | - on [Default]
| | | * Enable UCM-test (A3)
| | | - off [Default]
| | | - on, using drive
| | | - on, using brake
| | |
| | +- Brake test
| | | * Code for Tests
| | | * Brake test velocity
| | | - V0 (Creeping velocity)
| | | - V1
| | | - V2
| | | - V3
| | | - V4
| | | - V5
| | | - V6
| | | - V7
| | | - VN (Releveling velocity)
| | | - VI (Inspection velocity)
| | | - VR (Emerg. rescue velocity) [Default]
| | | * Enable brake test
| | | - off [Default]
| | | - on
| | |
| | +- Limit switch test
| | | * Code for Tests
| | | * Enable limit switch test
| | | - off [Default]
| | | - on
| | |
| | +- Driving monitoring
| | | * Code for Tests
| | | * Enable driving monitoring test
| | | - off [Default]
| | | - on
| | |
| | +- Functions
| | * Code for Tests
| | * Ignore overload signal until restart
| | - off [Default]
| | - on
| |
| +- Lock floors/doors
| | * Door disabling table 1..127
| |
| +- Times/statistic
| |
| +- Door cycle counter
| |
| +- Trip counter
| |
| +- Times
|
+- Enter calls
| |
| +- Car calls
| |
| +- Car calls handicap.
| |
| +- Low prio. car calls
| |
| +- Landing calls
| |
| +- Landings up
| |
| +- Landings down
| |
| +- Landing calls extra
| |
133