Böhnke + Partner bp308 - Page 130

| | * Doors during maintenance
| | - Normal [Default]
| | - Keep doors closed, until reset
| | - Keep doors closed, still after reset
| | * Drive to the service floor
| | off/1..16 [off]
| | * Enable the service position to be in the shaft pit area
| | - off [Default]
| | - on
| | * Enable assembly mode
| | - off [Default]
| | - on
| | * Assembly mode with pre-limit switches (S81/S82)
| | - off
| | - on [Default]
| | * Ignore safety light curtain or door sill on assembly mode
| | - off [Default]
| | - on
| | * Enable Ero outside limits
| | - off [Default]
| | - turned on once
| | - permanent activated
| | * Enable door open/close button on Inspection control
| | - off [Default]
| | - on
| | * Floor display on Ins/Ero
| | - off [Default]
| | - on
| | * Controlled deceleration on Ero operation
| | - on [Default]
| | - off
| | * Enable Inspection drive by turning maintenance on
| | - off [Default]
| | - on
| | * Inspection speed
| | - Slow [Default]
| | - Fast
| | * Inspection run operated by car panel
| | - off [Default]
| | - on
| | * Enable remote activation oversp. gov.
| | - off [Default]
| | - on for 5 minutes
| | - permanent on
| | * Drive tuning operation
| | - off [Default]
| | - on
| | * Drive data transfer from electronic nameplate
| | - off [Default]
| | - Execute
| | * UPS-Test operation mode
| | - off [Default]
| | - Short test
| | - Long test
| |
| +- Maintenance settings
| | * Trip counter interval
| | off/1..4294967295 [off]
| | * Hourly meter interval
| | off/0.1..429496729.5 [off] h
| | * Maintenance date
| | * Cyclic interval trip counter
| | off/1..4294967295 [off]
| | * Cyclic interval hour meter
| | off/0.1..429496729.5 [off] h
| | * Cyclic interval in months
| | off/1..65535 [off]
| | * Set new maintenance intervals
| | - off [Default]
| | - Execute
| |
| +- Maintenance stack
| |
| +- System data
| | |
| | +- Print system data
| | |
| | +- Print menu tree
| | |
| | +- Save logs
132