Böhnke + Partner bp308 - Page 148

| | - on, stop immediately blocked
| | * Low pressure monitoring (51)
| | - off [Default]
| | - on, stop immediately
| | - on, stop immediately blocked
| | * Safety valve monitoring 2 UCM/A3
| | - off [Default]
| | - on
| | * Inspection speed
| | - Slow [Default]
| | - Fast
| | * Transmit mode
| | - event-driven [Default]
| | - Cyclic
| |
| +- Relevelling
| | * Relevelling
| | - off [Default]
| | - on
| | * Max. number relevelling per floor
| | 1..20/Unlimited [10]
| | * Monitor the door cam lock (19) sig. if releveling
| | - on [Default]
| | - off
| | * Re-leveling only, if doors closed
| | - off [Default]
| | - on
| | * Signal Destination pending (153) while relevelling
| | - off [Default]
| | - on
| |
| +- Drop protection
| | * Drop protection
| | - off [Default]
| | - on
| | * Drop protection on inspection operation
| | - on [Default]
| | - off
| | * Drop protection optionally used for UCM protection
| | - off [Default]
| | - on
| | * Hold drop protection activated
| | - off [Default]
| | - on
| |
| +- Pawl device
| * Pawl device
| - off [Default]
| - on
| * Car seated using level signal
| - off [Default]
| - on
| * Pawl device lifting/lowering tries
| 1..10 [3]
| * Car seated using fine adjustment unit
| - off [Default]
| - on
| * Door lock rule, if pawl device is not extended
| - Unlock the door immediately
| - Unlock the door delayed by 45 min [Default]
|
+- Tripcnt/hours meter
| * Trip counter (SRAM)
| 0..4294967295 [0]
| * Hour meter (SRAM)
| 0.0..429496729.5 [0.0] h
| * Direction change counter (SRAM)
| 0..4294967295 [0]
| * Direction change count flex limit advance warning
| off/1..4294967295 [off]
| * Block lift on direction change count flex renew
| off/1..4294967295 [off]
|
+- Date/Time
|
+- Sundries
|
+- Access codes
| * Setup code
| * Service code
150