Böhnke + Partner bp308 - Page 147

| |
| +- General
| | * Drive with integrated contactors
| | - off [Default]
| | - on
| | * Enable of drive control (693)
| | - off [Default]
| | - Up
| | - Down
| | - No direction
| | * Enable of drive control (693)
| | - off [Default]
| | - Up
| | - Down
| | - No direction
| | * Fast start while doors are closing
| | - off [Default]
| | - on
| | * Contactor release check (33)
| | - off
| | - on
| | - on, lift blocked [Default]
| | * Contactor release check separate relevelling unit
| | - off [Default]
| | - on
| | * Drive unit monitoring with blocking mode
| | - off [Default]
| | - on
| | * Drive unit monitoring with blocking mode
| | - off [Default]
| | - on
| | * Drive unit monitoring (34)
| | - off [Default]
| | - on
| | - on, lift blocked
| | * Drive unit monitoring (34)
| | - off [Default]
| | - on
| | - on, lift blocked
| | * Drive unit monitoring with blocking mode
| | - off [Default]
| | - on
| | * Ignore drive unit status on Blue Modus
| | - off [Default]
| | - on
| | * Brake monitoring
| | - off [Default]
| | - Using 1 switch
| | - Using 2 switches
| | - Using 3 switches
| | - Using 4 switches
| | * Brake monitoring with blocking mode
| | - off [Default]
| | - on
| | * Safety brake monitoring (330)
| | - off [Default]
| | - on
| | - on, lift blocked
| | * Rope brake monitoring (451)
| | - off [Default]
| | - on
| | - on, lift blocked
| | * Brake test monitoring (691)
| | - off [Default]
| | - on
| | * Motor thermistor monitoring (450)
| | - off
| | - on, stop at floor [Default]
| | - on, immediately
| | - on, blocked mode at floor
| | - on, blocked mode immediately
| | * Phase monitoring (54)
| | - off
| | - on, stop at floor
| | - on, immediately [Default]
| | - on, blocked mode at floor
| | - on, blocked mode immediately
| | * Overpressure monitoring (50)
| | - off
| | - on, stop immediately [Default]
149