Böhnke + Partner bp308 - Page 146

| | | - V3
| | | - V4
| | | - V5
| | | - V6
| | | - V7
| | | - VN (Releveling velocity)
| | | - VI (Inspection velocity)
| | | - VR (Emerg. rescue velocity)
| | | * Velocity docking service floor 1..8
| | | - V0 (Creeping velocity) [Default]
| | | - V1
| | | - V2
| | | - V3
| | | - V4
| | | - V5
| | | - V6
| | | - V7
| | | - VN (Releveling velocity)
| | | - VI (Inspection velocity)
| | | - VR (Emerg. rescue velocity)
| | |
| | +- Automobile Lift
| | | * Function
| | | - off [Default]
| | | - on, signal lights "Forward-Stop-Back-Drive Out"
| | | - on, signal lights "Red-Green"
| | |
| | +- Special functions
| | * Car preference with car doors open
| | - off [Default]
| | - on
| | * Code input
| | - off [Default]
| | - on, triggered by pressing a disabled car call
| | - on, triggered by activation signal (696)
| | * Code input, number of digits
| | 1..10 [4]
| | * Door side alternate locked call processing
| | - off [Default]
| | - on
| | * Shuttle between top/bottom using the bottom car call
| | - off [Default]
| | - on
| | * Above the lobby, use only empty cars for landing calls
| | - off [Default]
| | - on
| | * Door open button acts on last door opened by call
| | - off [Default]
| | - on
| | * Hold car preference/VIP (84) signal, as long car calls are pending
| | - off [Default]
| | - on
| | * Car allocation remains active as long as allocation time is not expired
| | - off [Default]
| | - on
| |
| +- Floor Selector
| | * Direction of correction run
| | - Bottom floor [Default]
| | - Top floor
| | * Extended Level monitoring (224)
| | - off [Default]
| | - on
| | * Relevelling with separate switches
| | - off [Default]
| | - on
| | * Pre-limit switches (S81/S82)
| | - off [Default]
| | - on
| | * APS offset correction
| | - off [Default]
| | - top
| | - bottom
| | - top and bottom
| | - zone
| | * Rotation sense monitoring
| | - on [Default]
| | - on, lift blocked
| |
| +- Drive unit
148