Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
2. When the tamper condition is reset, send the restored report to the configured
destinations.
P The FAULT indicator is turned off when there is no other system fault.
– Zone Expansion Module 1-6 Tamper
Condition:
A disassembly of DX2010 module 1, 2, 3, 4, 5, or 6 is detected and the occurrence of zone
extension module 1, 2, 3, 4, 5 or 6 is considered as a tamper condition.
Restore:
4 Restore the DX2010 module 1, 2, 3, 4, 5, or 6 to a normal condition and reset the fault.
For more information, refer to DX2010, page 16.
Supervise:
1. Report the tamper condition to configured destination on address 0124 when the tamper
condition is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
2. When the tamper condition is reset, send the restored report to the configured
destinations.
P The FAULT indicator is turned off when there is no other system fault.
– Zone Tamper 1-16 DEOL
Condition:
Tamper contact is triggered (if the corresponding zone is programmed as DEOL).
Restore:
4 Restore the tamper contact and reset the tamper condition.
Supervise:
1. Report the sensor tamper to configured destination on address 124 when the sensor
tamper is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
2. When the tamper condition is reset, send the restored report to the configured
destinations.
P The FAULT indicator is turned off when there is no other system fault.
– Zone type 1-16 Tamper
Condition:
Tamper contact (directly connected to the zone) is triggered (zone type = tamper).
Restore:
4 Restore the tamper contact and reset the tamper condition.
Supervise:
1. Report the tamper condition to configured destination on address 124 when the tamper
condition is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
2. When the tamper condition is reset, send the restored report to the configured
destinations.
P The FAULT indicator is turned off when there is no other system fault.
– Keypad Lock out
Condition:
150
en | Troubleshooting AMAX 2100 / 3000 / 4000
2014.11 | 02 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
