If the number of incorrect code entries reaches the specified limit (programmed in address
0499), the keypad locks.
Restore:
4 Wait until the keypad lockout time (3min) expires and reset the fault.
Supervise:
1. Report the keypad lock out to configured destination on address 124 when the keypad
lock out is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
2. When the keypad lock out condition is reset, send the restored report to the configured
destinations.
P The FAULT indicator is turned off when there is no other system fault.
– RF Receiver Tamper
Condition:
A receiver is in tamper condition (e.g. when someone removes the device from its base or
pulls it out of the wall) if a wireless module is enabled.
Restore:
4 Restore the receiver and reset the tamper condition. For more information refer to RF
Devices, page 78.
Supervise:
1. Report receiver tamper fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
2. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off when there is no other system fault.
– RF Repeater Tamper
Condition:
A repeater is in tamper condition (e.g. when someone removes the device from its base or
pulls it out of the wall) if a wireless module is enabled.
Restore:
4 Restore the repeater and reset the tamper condition. For more information refer to RF
Devices, page 78.
Supervise:
1. Report repeater tamper fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
2. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off when there is no other system fault.
8 - External Failure
– External Fault Zone 1-16
Condition:
A fault contact (direct connected to the zone) is triggered (zone type = external fault).
Restore:
4 Restore the fault contact and reset the fault.
Supervise:
1. Report the fault condition to configured destination on address 124 when the fault
condition is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
AMAX 2100 / 3000 / 4000
Troubleshooting | en 151
Bosch Sicherheitsysteme GmbH Installation Guide 2014.11 | 02 | F.01U.267.112
To Next Page
Loading...
