Bosch Solution 16plus Installation Manual

5-2
Bosch Security Systems 05/10 BLCC100I
Solution 16
plus
 Installation Manual  Access Programming
USE R D EFAULT TA BL E
Parameter User 1 User 2 - 48
Add PIN 2580
Name User 1 User 2 - 48
Area Assignment 1 1
User Options
Has Master PIN Privileges Y
Expire PIN Code
Is Arm Only Code
Can Bypass Zones Y Y
Can Auto Bypass Zones Y Y
Send ‘Open/Close’ Reports Y Y
Timer Group
Access Group
Table 19: User Default Programming Options
USE R P IN CODE S
At factory default, each PIN is set to 4 digits in length. The
default PIN for User 1 (Master user) is 2580. Only the Installer
can change the PIN Length see MENU 1-5-0 — PIN Length.
Access > PIN Codes >
Erase User

-

MENU 1-0-0
This command allows the installer or a master code user, to
erase the user. When an installer erases a user, it will return back
to factory default all information relating to the following:
 PIN
 Token ID
 RF Keyfob ID
 Name
 Timer Group
 Access Group
 Area Assignment
1) Enter [MENU] + [1] + [0] + [0] and using the arrow keys
highlight the user to be erased then press [OK].
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press
 OK or MENU
2) Verify the user name to be erased and press [OK].
To abort press [MENU].
To Erase user Ur001
John Smith
Press OK.
Press OK or MENU
Access > PIN Codes >
Change Own PIN

-

-

MENU 1-1-0
This command allows a user to change their own PIN. The
new PIN should have the same number of digits as the old
PIN unless the variable code length option has been enabled.
See MENU 1-5-0 — PIN Length.
1) Enter [MENU] + [1] + [1] + [0]. The keypad will prompt you to
enter a new PIN.
Enter New PIN for
Debbie Smith Ur002
Press OK or MENU
2) Enter the new PIN, then press [OK]. If the error message “PIN
Not Allowed” is displayed , press [OK] and try a dierent PIN.
3) The keypad will now prompt you to conrm the new PIN again.
Confirm New PIN for
Debbie Smith Ur002
••••
Press OK or MENU
i
Note
If you attempt to enter a new PIN which already exists the
system will display PIN Not Allowed. The next time the original
PIN holder disarms the system they will be notied that their PIN
code has been compromised. The compromised PIN message
will continue to be displayed until the original user changes their
PIN.
Access > PIN Codes >
Change Other PIN

-

MENU 1-1-1
This command allows the Installer or Master user to change
other user PINs. The Master User can only change PINs for other
users in the same area.
The new PIN should have the same number of digits as the old
PIN unless the variable code length option has been enabled.
See MENU 1-5-0 — PIN Length.
1) Enter [MENU] + [1] + [1] + [1] and use the up and down arrows
to highlight the user in the list then press [OK].
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press
 OK or MENU
2) Enter the new PIN, then press [OK]. If the error message “PIN
Not Allowed” is displayed , press [OK] and try a dierent PIN.

Bosch Solution 16plus Specifications

General

Brand	Bosch
Model	Solution 16plus
Category	Security System
Language	English