9-2
Bosch Security Systems 05/10 BLCC100I
Solution 16
plus
Installation Manual Comms Programming
Domestic Phone Number 2
86538_
Press 0-9 OK to SAVE
5) When the second number is complete press [OK] to program
telephone number 3 if required.
Domestic Phone Number 3
73653_
Press 0-9 OK to SAVE
6) When nished press [OK] to save and exit or press [MENU] to
cancel.
Comms > Commands >
Call / Answer RAS (SolutionLink)
-
-
MENU 5-0-1
This command allows you to initiate a modem call to an o-
site computer for programming changes or updates. The o-
site computer must be connected to the telephone line that is
programmed in the call back telephone number and be set to
wait for an incoming call from the same customer that initiates
the modem call.
If the phone is ringing and this command is enetered, then the
panel will answer the call and attempt to start a SolutionLink
RAS session.
Comms > Commands >
Call Forward On/Off
-
MENU 5-0-2
This command allows you to turn on and o the call forward
feature. When you turn on call forwarding, the panel will
automatically activate and de-activate the call forward on and
call forward o sequence accordingly when you turn Area 1 All
On and O (arm and disarm).
1) Enter [MENU] + [5] + [0] + [2]. If the call forward status is OFF,
the keypad will display:
Call Forward On/Off
Call Forward is OFF
To turn ON, Press ON
To Go Back Press OK
If the call forward status is ON, the keypad will display:
Call Forward On/Off
Call Forward is ON
To Turn OFF, Press OFF
To Go Back Press OK
2) To toggle call forward on, press the [ON] key or press the [OFF]
key to turn call forward o.
3) Press [OK] to save and exit, or press [MENU] to cancel.
See MENU 5-1-6 and MENU 5-1-7 to program the Call Forward
ON and Call Forward OFF number sequence.
Comms > Commands >
Check Web Email
-
MENU 5-0-3
Reserved
Comms > Commands >
Email System Log
-
MENU 5-0-4
Reserved
Comms > Commands >
Start Direct Link Session
-
MENU 5-0-5
This menu allows the installer or master user to start a direct link
session without the need to press and hold the default button
on the control panel.
1) Enter [MENU] + [5] + [0] + [5]. The keypad will display the
following:
Waiting for Direct Link
Attempt!
Press OK or MENU
Once the computer and control panel establishes a connection,
the command will automatically exit.
2) Press [OK] or [MENU] to exit.
Comms > Commands >
Voice Setup
-
MENU 5-0-6
This menu allows the master user to record their own customised
greeting and zone description message that will be played back
to users that are programmed to receive domestic telephone
calls from the alarm system.
These messages should be clear enough so that the user
receiving the telephone call from the control panel can then
take the appropriate action.
This feature requires an optional voice module to be tted to
the control panel by your installer. Additional programming
information is included with the voice module.
PHO NE NUM BER P R OGR AMM ING
Comms > Telephone Number >
Number Prex
MENU 5-1-0
1 Digits 32
The number prex allows you to program the customer
To Next Page
Loading...
Need help?
General
