Bosch Solution 16plus - Delete Keyfob; Test Keyfob; User Name; User Properties

5-5
Bosch Security Systems 05/10 BLCC100I
Solution 16
plus
 Installation Manual  Access Programming
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press
 OK or MENU
2) Enter the RF Keyfob ID Number.
Enter Keyfob RFid for
Ur002 Debbie Smith
009553507
Press OK or MENU
3) Press [OK] to save and exit or press [MENU] to exit without
saving.
Access > RF Keyfob >
Delete Keyfob

-

MENU 1-3-1
This command allows the Installer or a Master User to delete an
RF Keyfob ID that has been assigned to a user.
1) Enter [MENU] + [1] + [3] + [1] and use the up and down arrows
to highlight the user in the list then press [OK]. The system will
only list users that have an RF Keyfob assigned.
Ur001 John Smith
Ur002 Debbie Smith
Ur003 Mary Smith
Press
 OK or MENU
2) Press [OK] to delete the RF Keyfob ID number and exit or press
[MENU] to exit without saving.
OK to delete keyfob for
Ur002 Debbie Smith
009553507
Press OK or MENU
.
Access > RF Keyfob >
Test Keyfob

MENU 1-3-2
This menu allows the installer to test the RF Keyfob operation.
Key the transmitter a number of times and the display will show
the number of transmissions received and a signal level of
GOOD, BAD or AVERAGE.
1) Enter [MENU] + [1] + [3] + [2] and use the up and down arrows
to highlight the user in the list then press [OK]. The system will
only list users that have an RF Keyfob assigned.
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press
 OK or MENU
2) Press any key on the transmitter you wish to test.
Ur002 Debbie Smith
Waiting for Trigger!
Press OK or MENU
3) If the system receives the signal the following screen will
appear.
Ur002 Debbie Smith
Transmissions = 001
Signal = Average
Press OK or MENU
4) Repeat step 2 as required and then Press [OK] to exit.
USE R P ROP E RT IES
This section outlines user properties including User Name, Area
Assignment, User Options, Erase User and Access Group.
Access > User Properties >
User Name

-

MENU 1-4-0
U s e r 1 N a m e
This menu allows the security Installer or a Master user to
program the user’s name (max of 16 characters). This name is
used for System Greetings, Reporting and Log entries to identify
the user by name.
1) Enter [MENU] + [1] + [4] + [0] and use the up and down arrows
to highlight the user in the list then press [OK].
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press
 OK or MENU
2) Use the arrow and number keys to move and change text.
When the User Name is complete, press [OK]. At any time you
can press the [OFF] key to clear the text from the current cursor
position to the end of the line.
User Name Ur001
User 1 Name
Press  OK or MENU
i
Note
See Alpha Text Programming in Section 4 — Programming
Overview for further detail on entering alpha text.