Bosch Solution 16plus - Add PIN; Delete PIN; User Tokens; View PIN

5-3
Bosch Security Systems 05/10 BLCC100I
Solution 16
plus
 Installation Manual  Access Programming
Please Enter PIN for
Debbie Smith Ur002
••••
Press OK or MENU
3) Press [OK] to save and exit or press [MENU] to exit without
saving.
i
Note
If you attempt to enter a new PIN which already exists the
system will display PIN Not Allowed. The next time the original
PIN holder disarms the system they will be notied that their PIN
code has been compromised. The compromised PIN message
will continue to be displayed until the original user changes their
PIN.
Access > PIN Codes >
Add PIN

-

MENU 1-1-2
This command allows the Installer or Master user to add a PIN
for a user that currently does not have a PIN assigned.
The Master user can only program a new PIN for users that have
been assigned to the same area(s) as the Master user.
1) Enter [MENU] + [1] + [1] + [2] and use the up and down arrows
to highlight the user in the list then press [OK]. The system will
only list users that dont already have PINs assigned.
Ur006 User 6 Name
Ur008 User 8 Name
Ur010 User 10 Name
Press
 OK or MENU
2) Enter the new PIN, then press [OK]. If the error message “PIN
Not Allowed” is displayed , press [OK] and try a dierent PIN.
Enter New PIN for
User 10 Name Ur010
••••
Press OK or MENU
3) Press [OK] to save and exit or press [MENU] to exit without
saving.
i
Note
If you attempt to enter a new PIN which already exists the
system will display PIN Not Allowed. The next time the original
PIN holder disarms the system they will be notied that their PIN
code has been compromised. The compromised PIN message
will continue to be displayed until the original user changes their
PIN.
Access > PIN Codes >
Delete PIN

-

MENU 1-1-3
This menu allows security installers and Master Users the ability
to delete other users PINs. A Master user can only delete a PIN for
users that have been assigned to the same area(s). The Installer
and Master user cannot delete their own PIN.
1) Press [MENU] + [1] + [1] + [3] and use the up and down arrows
to highlight the user in the list then press [OK]. The system will
only list users that can be deleted.
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press
 OK or MENU
2) Press [OK] to delete the PIN or press [MENU] to cancel.
Press OK to delete PIN
User Ur002 Debbie Smith
Press OK or MENU
Access > PIN Codes >
View PIN

MENU 1-1-4
This menu allows the Installer to view the actual PIN for any user.
1) Press [MENU] + [1] + [1] + [4] and use the up and down arrows
to highlight the user in the list then press [OK].
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press
 OK or MENU
2) The PIN will always display 8 digits however only the number
of digits corresponding to the global PIN Length setting are
valid.
View PIN Ur001
25800000
Press 0-9 OK to SAVE
3) Press [OK] to save and exit or press [MENU] to exit without
saving.
USE R TOK ENS
This section outlines how to add and delete tokens. Tokens
provide an alternate method for users to turn the system on and
o or operate a door strike.
A token is a plastic card that has a unique ID number. Each user
can be assigned a PIN as well as a Token for greater exibility.
A Token can be presented to a keypad with a built in reader or to
an external reader module to operate the system.
Tokens will follow all user settings.