EasyManua.ls Logo

Boschert CU - PROFI - Safety-Oriented Working

Boschert CU - PROFI
139 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
Tel.: + 49 / 07621 / 95 93 0
Fax: + 49 / 07621 / 55 184
infoak@boschert.de
www.boschert.de
Mattenstrasse 1
79541 Lörrach-Hauingen
BOSCHERT
Version: 05 / 2011Changes reserved
Safety
1.6 Safety-oriented working
The operating staff* must:
- observe the safety notices contained in this OM,
- know where the EMERGENCY-OFF buttons are located,
- observe the factory´s instructions regarding work, operation and safety.
It must be ensured:
- that the machine is switched off before any maintenance and repair work is started
and that it is safeguarded against accidental switching on (main switch on the
control cabinet is locked),
- up to 3 locks can be present,
- each work group (electricians, fitters) should attach its own lock; thus, each group
can prove that all safety and protective equipment are mounted and checked after
maintenance and repair and before commissioning,
- that only lifts with appropriate load-bearing capacity are used,
- that the machine is lifted only with the specified tools,
- that the manufacturer´s notices are observed when using chemicals (solvents,
cleaning agents, etc.),
It is forbidden:
- to conduct any work on the machine during operation,
- to perform alterations to the machine without the manufacturer´s permission,
- to use working methods, which affect the safety of the machine,
- to open doors, flaps or protective equipment during operation or to operate the
machine without these parts.
Removing, bridging or overriding
safety installations is absolutely
forbidden!
Never operate the machine when you
have taken alcohol or illegal drugs.
* Operating stuff in the sense of the EU Official Journal 183, annex I, clause 1.1.1 section 3 are the person(s), who is/are responsible for
installation, operation, setting up, maintenance including cleaning, fault correction and transport of a machine.
Never use gasoline or nitro-dilutions for cleaning. These substances develop
readily flammable vapours.
One spark (cigarette) is enough to cause
ignition.
This can result in most serious burns.
Danger

Table of Contents

Related product manuals