Boschert CU - PROFI - Other Notices Concerning Dangers; Unauthorised Conversion and Manufacture of Spare Parts; Special Features of the Machine

25
Tel.: + 49 / 07621 / 95 93 0
Fax: + 49 / 07621 / 55 184
infoak@boschert.de
www.boschert.de
Mattenstrasse 1
79541 Lörrach-Hauingen
BOSCHERT
Version: 05 / 2011Changes reserved
1.16 Other notices concerning dangers
1.17 Unauthorised conversion and manufacture of spare parts
1.18 Special features of the machine
- It is forbidden to stay under suspended loads.
- Immediately remove spilled oils, fats, etc.
- Keep the machine and the area around the machine
tidy and clean.
- Local safety and accident prevention regulations apply
also to the operation of the machine.
- Any junk and rubbish (paper, plastics, residual oil,
solvents, etc.) must be disposed of by experts (observe
applicable laws and regulations).
Operator: Notify your superior about any changes
regarding normal operation of the machine.
Have them removed! Always switch off the
machine when it is unattended.
- Conversion of or changes to the machine are permitted
only upon agreement by the manufacturer.
- Original spare parts and accessories that are
authorised by the manufacturer contribute to your
safety. Using other parts may change the functioning of
the machine. We assume no liability for any
consequences resulting from the use of such parts. It is
imperative that you contact us before taking any such
action.
- Metal sheet is displaced during machining. Large
sheets may protrude beyond the front and lateral
edges of the machine table.
It is imperative to safeguard these areas.
- The actual travelling paths and the machining
sequence do not always correspond with the
programmed sequence since the machine
calculates its own paths and sequences on the
basis of the optimizer.
Danger
Safety