BOSCHERT
31
Tel.: + 49 / 07621 / 95 93 0
Fax: + 49 / 07621 / 55 184
infoak@boschert.de
www.boschert.de
Mattenstrasse 1
79541 Lörrach-Hauingen
Version: 05 / 2011Changes reserved
Description
3.1 Mechanical construction
3 Description
3.2 Designated utilisation
The machine is exclusively designated for punching CU-flats. Any other or this purpose
exceeding utilisation, e.g. exceeding of ceiling technical data, is considered as not in
accordance with the designated purpose. The manufacturer / supplier is not liable for
damages resulting from such actions. The risk is exclusively run by the user.
3.3 Operation possibility
- With the CU-PROFI you have a machine to punch and cut CU-flats up to a breadth of
200 mm.
- The raw material can be arbitrarily long.
- The roller race on the intake side must be adapted to the material length.
The finished work piece should´nt be longer than 2000 mm. Because the tilting table is
conceived only for 2 m material.
Longer workpieces must be unloaded with switched off tilting table by hand.
Then the theoretical lengthens amounts to 9999 mm.
- Please consider the discharge zone behind the machine.
- Sturdy weldment.
- Hydraulic punch actuation from tools.
- Programming of the sheet and punch motion via
CNC 32060.
To Next Page
Loading...