Boschert CU - PROFI - Page 4

4
Tel.: + 49 / 07621 / 95 93 0
Fax: + 49 / 07621 / 55 184
infoak@boschert.de
www.boschert.de
Mattenstrasse 1
79541 Lörrach-Hauingen
BOSCHERT
Version: 05 / 2011Changes reserved
List of contents
5.13.1 Limit switch Y-axis ..........................................................................................59
5.13.2 Limit switch X-axis ...........................................................................................60
5.13.3 Limit switch tilting table ..................................................................................61
5.13.4 Limit switch clamp..........................................................................................61
5.14 Limit stops axes .............................................................................................62
5.15 Sprayer ...........................................................................................................63
5.15.1 Spray assembly ..............................................................................................63
6 Setup of the machine ............................................................... 64
6.1 General information........................................................................................64
6.2 The operator´s control on the machine.........................................................64
6.2.1 The operator´s control on the control cabinet ..............................................64
6.2.2 The operator´s controls on the control desk.................................................65
6.2.3 The foot pedal for the hydraulic material clamping .......................................65
6.3 Preparation of the machine for punching ......................................................66
6.3.1 Providing a punching tool ..............................................................................66
6.3.2 Insert the die ..................................................................................................66
6.3.3 Installation of AMADA - Station ......................................................................67
6.4 Preparation of the machine for cutting ..........................................................68
6.4.1 Providing a cutting tool ..................................................................................68
6.4.2 Insert the die ..................................................................................................68
6.4.3 Insert the cutting punch .................................................................................68
6.5 Insert the CU-flat ............................................................................................69
6.6 Starting the machine ......................................................................................70
6.7 Stopping the machine....................................................................................71
6.8 Restarting the machine ..................................................................................71
7 Maintenance ............................................................................. 72
7.1 Maintenance and inspection..........................................................................72
7.1.1 General information........................................................................................72
7.2 Maintenance and inspection list ....................................................................73
7.3 Cleaning the machine ....................................................................................74
7.3.1 Auxiliary agents and their use ........................................................................74
7.4 Lubrication......................................................................................................75
7.4.1 Lubrication points...........................................................................................76
7.4.1.1 Lubrication points X-axis ................................................................................77
7.4.1.2 Lubrication points Y - axis..............................................................................77
7.4.1.3 Lubrication points punch head ......................................................................78
7.4.1.4 Lubrication point tool box ..............................................................................79
7.4.1.5 Lubrication points clamp ...............................................................................79
7.5 Corrosion prevention .....................................................................................80
7.5.1 Notes on corrosion prevention agents, oils and lubricants...........................80
7.5.2 Disposal of corrosion-preventing agents, oil and lubricants .........................80
8 Hydraulic................................................................................... 81