140
Fixing the pitch of vocals/Adding a backing chorus to vocals (Vocal Tool Box)
Rev0.02
Saving Vocal Tool Box
settings (Patch Write)
Modified Vocal Tool Box settings are saved by writing them
together under a new patch name.
1.
Press [F1] (NAME) on the Pitch Correction or Harmony
Sequence screen.
The patch name setting screen will appear.
fig.35-11d
2.
Move the cursor to the characters in the patch name you
want to change and select new characters using the
TIME/VALUE dial.
fig.35-11ad
3.
Press [EXIT/NO] twice to return to the Vocal Tool Box
Patch Selection screen.
fig.03-3781d
4.
Press [F3] (WRITE•COPY).
The Vocal Tool Box Write/Copy screen will appear.
fig.35-12d
5.
Move the cursor to the destination patch number and
select a destination patch using the TIME/VALUE dial.
fig.35-13d
This field should be left unchanged at “*TMP(CURRENT).”
If a different message is displayed, however, move the
cursor to this field and turn the TIME/VALUE dial
counterclockwise to restore “*TMP(CURRENT).”
6.
Press [F3] (GO).
The Vocal Tool Box patch will be written. When this
process has been completed, the Vocal Tool Box patch
screen will be displayed once again.
7.
Press [EXIT/NO] several times to return to the top
screen.
BR-1200CD_e.book 140 ページ ２００７年８月２４日 金曜日 午前１１時３３分
To Next Page
