BRAILLO
l
B 650 SF
91
4.15 Beam wheel sensor - Adjustment
The Beam wheel sensor is placed on the lower shaft, on the opposite end from the belt.
Note that this adjustment has to be done with the shafts positioned like on the gure with the arrows
pointing towards each other. The notch on the beam wheel should now be placed exactly opposite the
sensor like in the gure below.
If the edge is not in it’s correct position, it must be adjusted.
Keep the shafts in this position while loosening the two screws holding the beam wheel. Turn the beam
wheel until the notch on the beam wheel is placed in the middle of inductive sensor. Then fasten the
two screws.
Keep the shafts in
this position
The notch must be
in the middle of the
sensor
Sensor
To Next Page
Loading...