BRAILLO
l
B 650 SF
56
3.8 Messages in the Staple and Fold display
- Ready
The Staple and Fold unit is ready.
The signal tower will have a green light.
- Paused
The Staple and Fold unit is paused. This can happen for two reasons. The rst is when you select pause
on the main menu. The signal tower will have a green light.
Second is when a problem appears while the Printer is running.
Now the signal tower will have a red light.
To continue, turn off the Pause either by open and close one of the hatches, or select Pause on the main
menu. Now the Printer display changes to “Press Continue to resume”. Push the Cont.
button to resume.
- Lost sheet
The vacuum arm has detected a lost sheet.
The signal tower will have a red light.
To continue, open one of the hatches and place the sheet in the correct position manually. Close the
hatch, the Printer display changes to “Press Continue to resume”. Push the Cont. button to resume.
- Replace Paper roll
The paper roll needs to be replaced soon.
The signal tower will have a yellow ashing light.
The actual roll diameter that will start this alarm can be set by the user.
Note! The Printer will not stop, this is just a reminder to make you keep an eye on the paper roll.
- Servo alarm
Vacuum arms horizontal movement is malfunctioning in some way.
The signal tower will have red and green ashing light.
The system needs a restart. Turn off the power, nd the reason for the error and turn the power back
on.
- Book eject
The nished stapled and folded book did not fall down. The signal tower will have a red light.
When a book is nished, a sensor must register the book falling down within a certain period of time.
If it does not fall down, the book might be stuck in the hatch opening. To correct the problem, slide the
book over the sensor and open and close one of the hatches.
Now the Printer display changes to “Press Continue to resume”. Push the Continue button.
To Next Page
Loading...