Brainboxes ED-549 - Factory Default Settings

Ethernet Analogue DIO
Product Manual V1.3
© Copyright Brainboxes Ltd
Page 52 of 100
Restore Factory Default
Clicking the ‘Restore Factory Default’ button will revert all the settings on the device back to their factory
default. Just like restarting the device, in order to restore the factory settings, there must be no connection to
the device active. For a list of the factory settings of the device please see section 6.8 Factory Default Settings.
Factory Default Settings
Network Settings
Network IP Address
DHCP Mode
Web Server Port
80
ASCII Protocol Settings
Device Address
01
TCP Port
9500
Idle Timeout
0
Data Format
Engineering unit
Checksum
Disabled
Serial Expansion Settings
Baud Rate
9600
Command Timeout
200ms
Modbus Protocol Settings
Slave IDs
Respond to IDs 0 and 255 only
Accept All Addresses
Disabled
TCP Port
502
Max connections
8
Idle Timeout
0 (disabled)
Data Format
Engineering unit