Brainboxes ED-549 - Aars

Ethernet Analogue DIO
Product Manual V1.2
© Copyright Brainboxes Ltd
Page 80 of 100
$aaRS
Applies to: All analogue input/output products
Description:
Command to reboot the device.
Note: The device can take a number of seconds to reboot. Close all connections to the device after sending the
command. Connection can be re-established once the device has rebooted.
Command Syntax:
$aaRS[CS](CR)
$
Delimiter character
aa
Address of the device to be reset in hexadecimal format (00 to FF)
RS
Command to reset the device
[CS]
Checksum
(CR)
Carriage Return
Response:
No response
Examples:
Send a command to reset the device. No response is expected.
Command: $01RS(CR)
No Response