Brainboxes ED-549 - Aas1

Ethernet Analogue DIO
Product Manual V1.2
© Copyright Brainboxes Ltd
Page 82 of 100
$aaS1
Description:
Command to reset the calibration parameters back to the factory default.
Command Syntax:
$aaS1[CS](CR)
$
Delimiter character
aa
Address of the device in hexadecimal format (00 to FF)
S1
Command to reset the calibration on the device
[CS]
Checksum
(CR)
Carriage Return
Response:
Valid Command: !aa[CS](CR)
Invalid Command: ?aa[CS](CR)
!
Delimiter for a valid command
?
Delimiter for an invalid command
aa
Address of the responding device
[CS]
Checksum
(CR)
Carriage Return
Examples:
Send a command to set the device back to the factory default calibration settings and a valid response is
returned.
Command: $01S1(CR)
No response: !01(CR)
Note: There is no response from the device in three circumstances. If the command syntax is incorrect, there is
a communication error or if no device with the address in the command can be found.