Brainlab KICK 2 - Performing Tests; Protective Earth Resistance

6.3 Performing Tests
6.3.1 Protective Earth Resistance
General Information
Connect the measurement tip of your measuring device with the conductive parts shown in the
table below and measure the resistance.
If a test does not pass, device must be repaired by Brainlab support. After repair, repeat the entire
electrical safety test from the beginning.
Protective Earth Resistance Test
Point Tested Measured Value Test
Passed?
Potential equalization port
Performing Tests
72 System and Technical User Guide Rev. 1.3 Kick 2 Navigation Station