Bredal F4 - Reloading Factory Settings; Restoring Original Factory Settings; Initiating Factory Settings Reload

42
If any values in the basic settings are mistakenly deleted or changed, the original factory settings can be reloaded. Note that any values that have
possibly been changed since the implement was delivered from the factory will be reloaded to the original values when the factory settings are
reloaded.
The values reloaded with this function are as follows:
• Application rate (cm
3
/impulse)
• Load cells’ calibration gures
• TC-implement osets
• No. of pulses per disc revolution
• No. of pulses per oil-motor revolution
• Gear factor for headland gear (headland-gear downshiing as a percentage).
• The proportional valves’ PID parameters
Aer reloading the factory settings, the spreader’s application rate and weighing should both be checked and monitored, as there is a risk of making
application errors if a reloaded gure is incorrect.
Press the
key from the Home screen display.
Select “Help”
Select “Load factory settings”
RELOAD FACTORY SETTINGS
Press to reload the factory settings.
Press
to return without making any changes.