Bredal F4 - Rear Door Setting Check; Importance of Rear Door Settings; Setting Rear Door Scale for Check

59
The basic setting of the rear doors must be correct in order for the spreader to apply correctly. It is possible to check the setting by setting the scale
at 200 and placing a 40 mm square pipe on the belt underneath the door. If the setting is incorrect, adjust the door on its tension rod.
Set the rear doors’ scale at 200
Place a 40 mm square pipe under the door. The square pipe should be able to move
freely under the door with almost no clearance. Adjust the door’s drawbar if this setting
is not correct.
CHECKING THE REAR DOORS AND THEIR BASIC SETTING