Bredal F4 - Headland Gear Lubrication and Adjustment; Headland Gear V-Belt Tension Adjustment

63
The headland gear’s claw clutch is protected by a plastic tube perforated by a 3 mm hole. Lubricate the clutch before the season begins and aer
every 100 operating hours by spraying a thin oil or rustproong oil through the hole.Always lubricate if the inside of the spread unit has been
washed and before putting the spreader into storage for the winter.
The spring that keeps the headland gear’s V-belt tight must be tightened to a length of 43–45 mm when the spread unit is cold. Check the tightness
aer the rst 20 hours of operation and then aer every 100 hours of operation. Re-tighten if the spring measures more than 45 mm.
> Lubrication and adjustment of headland gear