Bredal F4 - Final V-Belt Replacement Steps; Attaching Spring to Guide; Mounting Final Plastic Bearings

71
Attach the spring to the spring guide and insert the guide
into the hole.
Loosely mount the plastic bearing furthest to the right.
Mount the last two plastic bearings. If necessary, use a
crowbar or similar to move the shier sha into place.
Tighten all plastic bearings. Make sure the sha can still
freely rotate when tightening, i.e. do not overtighten.
If relevant, complete the process by attaching the hydraulic cylinder for shiing the
headland gear.