Briot Silver - Page 5

Table of contents
ii Silver FC 00 511
Emptying the internal memory________________________________________________ 50
Dressing the wheels _______________________________________________________ 51
Adjusting the lens sizes (reset sizes) __________________________________________ 53
Changing the lens feeler tip__________________________________________________ 57
Adjusting the Scanform™ ___________________________________________________ 58
Adjusting the lens feeling____________________________________________________64
Consulting the statistics_____________________________________________________ 65
Lens counters ___________________________________________________________________ 65
Wheel dressing __________________________________________________________________ 68
Lens feeler, lens size and Scanform™ adjustments _____________________________________ 69
Type of tracing __________________________________________________________________ 70
Messages __________________________________________________________71
Message types ___________________________________________________________ 71
List_____________________________________________________________________72
Origin: Scanform™ _______________________________________________________________ 72
Origin: Lay-out __________________________________________________________________ 72
Origin: Tracing __________________________________________________________________ 72
Origin: Edging ___________________________________________________________________ 73
Origin: Extension card ____________________________________________________________ 73
ANNEXES
Annex A Operation in recirculating mode
Installing the recirculating system ____________________________________________ A-3
Warning_______________________________________________________________________ A-3
Procedure _____________________________________________________________________ A-3
Illustration _____________________________________________________________________ A-3
Cleaning the Pump _______________________________________________________ A-4
Procedure _____________________________________________________________________ A-4
Emptying Main Tank ______________________________________________________ A-5
Annex B Use of the internal memory
Introduction _____________________________________________________________ B-3
Icons _________________________________________________________________________ B-3
Memory capacity________________________________________________________________ B-3
Using the internal memory__________________________________________________ B-4
Configuration___________________________________________________________________ B-4
Creating and Saving a Job ________________________________________________________ B-4
Advice ________________________________________________________________________ B-5
Call up a job saved in memory _____________________________________________________ B-5
Annex C Connection to the OMA network
Introduction _____________________________________________________________ C-3
Warning_______________________________________________________________________ C-3
Icons _________________________________________________________________________ C-3
Connection to the OMA network _____________________________________________ C-4
Configuration___________________________________________________________________ C-4
Creating and saving a job _________________________________________________________ C-4
Advice ________________________________________________________________________ C-5
Call up a job saved on the server ___________________________________________________ C-5
Job uploading function disabled ______________________________________________________ 6
Annex D Use of the barcode reader
Connection to the edger ___________________________________________________ D-3
Use ___________________________________________________________________ D-4
Annex E Technical Specifications
Technical characteristics ___________________________________________________ E-3