Briot Silver - Connection to the OMA Network; Configuration; Creating and Saving a Job

Annex C - Connection to the OMA network
C- 4 Silver FC 00 511
Connection to the OMA network
CONFIGURATION
The configuration of your edger is performed by a technician. For any changes to the
configuration or any information about this, please contact your supplier.
CREATING AND SAVING A JOB
Follow the steps below to create and save a job on the server.
Step Action
1
Press one or several times the Fct0 to access to tracing mode.
2
Enter a job number using the keyboard or the barcode reader.
3
Select the job origin using the key Fct7:
•
Or
•
Here, the Scanform™
.
4
Select the destination of this new job: press the key Fct8 and select
.
Result:
Your job will be saved on the server.
5
Enter the tracing parameters and
trace your job.
Refer to the section Creating a job.
6
Access the lay-out/blocking screen and
enter the job data (distance, height etc.).
Refer to the section Lay-out.
7
Access the edging screen and
enter the job data (lens type, bevel, etc.)
Refer to the section Edging.
8
Access the tracing screen again by pressing the key Fct0.
Fct 0
Fct 8Fct 7