Basic concepts
20 FC 00 511
BASIC CONCEPTS
Three Working Modes
The edger makes three basic operations corresponding to a screen called "mode" that you can
identify by a symbol located on right side of the screen.
Mode Screen Functions
Tracing Allow you to enter the following
parameters:
• job number
• frame type
• frame side to be traced
• frame PD or Bridge
• tracing type
• job destination
• job origin
Lens Layout/
Blocking
Allow you to enter the following
parameters:
• lens to be laid out
• vision type
• horizontal decentration
• height decentration
• segment width for near vision
• lay-out/blocking mode
• type of decentration
Edging Allow you to enter the following
parameters:
• lens to be edged
• lens type
• lens finishing type
• bevel type
• lens final size
• edging pressure
• polishing
To Next Page
