Maintenance : messages
Silver FC 00 511 73
Origin: Edging
The following table shows the messages that can be displayed in the edging mode.
N° Message Cause
04 01 Retouch impossible A retouch is required when a lens has not yet been
edged.
04 04 Small adapters mounted? Request for confirmation of job of small adapter
model (Ø19 mm).
04 05 Lens too small for shape Lens too small or too decentered in comparison with
the shape.
04 06 Radius < 10 mm Shape too small. (Try to work in boxing mode.)
04 07 Re edge same lens? Lens edging from a job on the screen already
edged.
04 08 Bevel too much at the back Top of the bevel more than 5 mm from the front
face.
04 10 Do you want to continue? This message appears when the edging time
exceeded the limit of the machine (8 min).
The operator has the choice to continue or stop the
edging process.
04 11 Lens too thick for rimless Lens thickness higher than 10.4 mm.
04 12 Finishing impossible Finishing time greater than 3 min (carriage contact
problem).
04 14 Impossible edge Problem on the main motor. Rotation speed too low
or null.
05 06 Bevel top out lens
Continue?
During automatic bevel, the machine detects that the
bevel may go out of the lens edge. Shall we finish
the lens?
05 07 Lens feelers : Aberrant spots Irregular points detected during lens tracing.
Example
: for a half-moon lens, the adhesive
has not been cut before blocking.
05 12 Small flat adapter mounted? The frame shape requires Ø17mm adapters. Make
sure it is mounted before continuing.
Origin: Extension card
The following list shows the messages linked to the extension card.
Type Message Cause
06 02 Job not found The frame recalled does not exist on the server.
To Next Page
Loading...
