Annex A - Operation in recirculating mode
Silver FC 00 511 A - 5
EMPTYING MAIN TANK
Follow the steps below to empty the main tank.
Step Action
1 Switch off the edger.
2
Press the
key while you switch on the edger.
Result:
the following screen is displayed.
3 Disconnect the main water supply pipe (edger side) and connect the dump pipe
to the main drain (bucket, sink, sewer, etc.).
4
Start the pump: press the Fct1 key and display
.
5 Turn on the faucet of the dump pipe.
Result: the main tank dumping starts.
6
When the emptying is finished, press the Fct1 key and display
.
Result: the pump stops.
7 Turn off the dump pipe faucet.
8 Re-connect the water supply pipe to the edger.
9
Press the
key to reboot the machine.
Fct1
To Next Page
Loading...
