EasyManua.ls Logo

Broadcom BCM7405 - Page 162

Broadcom BCM7405
194 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2/24/2008 9T6WP
BCM7405 Preliminary Hardware Data Module
Hardware Signal Descriptions 06/29/07
Broadcom Corporation
Page 1-148 Power-On Strap Settings Document 7405-1HDM00-R
strap_ebi_invert_addr 0: Do not invert EBI address
1: Invert upper bits of EBI address
EBI_RDb 1
strap_boot_rom_type 0: Boot ROM is NOR Flash
1: Boot ROM is NAND Flash
EBI_WE1b ? TBD
strap_pci_client 0: PCI in bridge (master) mode
1: PCI in client (slave) mode
VO_656_0 0 Usually in master mode
strap_pci_memwin_
size_0
0: 512 Mbyte Window
1: 1 Gbyte Window
2: 128 Mbyte Window
3: 256 Mbyte Window
(LSB is 0, MSB is 1)
VO_656_3 ? Per memory configuration
strap_pci_memwin_
size_1
DAA_AOUT
strap_pci_memwin1_e
n
0: Disable PCI memory window 1
1: Enable PCI memory window 1
VO_656_1 ? Per system configuration
strap_pci_memwin2_e
n
0: Disable PCI memory window 2
1: Enable PCI memory window 2
VO_656_2 ? Per system configuration
strap_external_MPI_
arbit
0: Use internal MPI arbiter
1: Use external MPI arbiter
EBI_WE0b 0 Per system configuration
strap_CPU_freq_0 0: 297 MHz
1: 324 MHz
2: 351 MHz (default)
3: 378 MHz
4: 405 MHz
5: 432 MHz
6: 459 MHz
7: 148.5 MHz (297 divided by 2)
EBI_ADDR25 0 Per system configuration
3'b010 is the recommended
default
strap_CPU_freq_1 EBI_RWb 0 Per system configuration
strap_CPU_freq_2 EBI_ADDR24 ? Per system configuration
strap_NMI_polarity 0: Low-active interrupt
1: High-active interrupt
EBI_TSb ? Per system configuration
strap_test_debug_en_
0
0: Debug Mode Disabled VO_656_5 0 Internal Debug Port
strap_test_debug_en_
1
VO_656_6 0
strap_spi_slave_
enable
0: BSC slave port configured
1: SPI slave port configured
IR_OUT 0 Per system configuration,
usually in BSC slave
strap_system_big_end
ian
0: System is LITTLE endian
1: System is BIG endian
RMX_SYNC1 ? Per system configuration
strap_USB_mode 0: 3rd USB is host mode
1: 3rd USB is client mode
AUD0_SPDIF 0 Per system configuration
strap_RSVD_1 USB0_PWRON 0 Per system configuration
strap_33_27_MHz_
clock
0: 27-MHz clock output
1: 33-MHz clock output
VO_656_7 1 Per system configuration
Table 1-20: Power-On Strap Settings
Strap Bit Description Pin Default Comments

Table of Contents

Related product manuals