Brocade Communications Systems MLX Series Hardware Installation Guide

Brocade MLX Series and NetIron XMR Hardware Installation Guide 249
53-1003821-01
Managing interface modules
6
Syntax: lp boot system mp [primary | secondary] [all | <slot-number>]
• The primary and secondary keywords specify the primary or secondary image in flash memory
on the management module.
• The all | slot-number parameter specifies that the automatic boot applies to all interface
modules in the device, or to an interface module in the specified device slot number only. You
can specify 1 – 4 for 4-slot devices, 1 – 8 for 8-slot devices, 1 – 16 for 16-slot devices, or 1 –
32 for 32-slot devices.
Configuring an automatic boot from flash memory on the interface module
To configure an automatic boot from the primary image in flash memory on the interface module
for all interface modules, enter the following command at the global CONFIG level of the CLI.
Brocade(config)# lp boot system flash primary all
Syntax: lp boot system flash [primary | secondary] [all | <slot-number>]
• The primary and secondary keywords specify the primary or secondary image in the interface
module flash memory.
• The all | slot-number parameter specifies that the automatic boot applies to all interface
modules in the device or to an interface module in the specified slot number only. You can
specify 1 – 4 for 4-slot devices, 1 – 8 for 8-slot devices, 1 – 16 for 16-slot devices, or 1 – 32 for
32-slot devices.
Configuring an automatic boot from a TFTP server
To configure an automatic boot for all interface modules from a TFTP server, enter the following
command at the global CONFIG level of the CLI.
Brocade(config)# lp boot system tftp 123.123.123.123 primary all
Syntax: lp boot system tftp <ip-address> <filename> [all | <slot-number>]
• The ip-address parameter specifies the IP address of the TFTP server from which the interface
modules will be booted.
• The filename parameter specifies the name of the image from which to boot the interface
modules.
• The all | slot-number parameter specifies that the automatic boot applies to all interface
modules in the router or to an interface module in the specified router slot number. You can
specify 1 – 4 for 4-slot routers, 1 – 8 for 8-slot routers, 1 – 16 for 16-slot routers, or 1 – 32 for
32-slot routers.
Configuring an automatic interactive boot
To configure an automatic interactive boot for all interface modules, enter the following command
at the global CONFIG level of the CLI.
Brocade(config)# lp boot system interactive all
Syntax: lp boot system interactive [all | <slot-number>]
The all | slot-number parameter specifies that the automatic boot applies to all interface modules
in the router, or to an interface module in the specified slot number. You can specify 1 – 4 for 4-slot
routers, 1 – 8 for 8-slot routers, 1 – 16 for 16-slot routers, or 1 – 32 for 32-slot routers.

Brocade Communications Systems MLX Series Specifications

General

Brand	Brocade Communications Systems
Model	MLX Series
Category	Network Router
Language	English