Brocade Communications Systems MLX Series - Displaying CPU Usage

Brocade MLX Series and NetIron XMR Hardware Installation Guide 259
53-1003821-01
Enabling and disabling management module CPU usage calculations
6
Syntax: cpu-usage on
To disable the usage averaging calculations, enter the following command at the global CONFIG
level of the CLI.
Brocade(config)# cpu-usage off
Syntax: cpu-usage off
Displaying CPU usage
Use the show cpu command to display usage averages for all tasks performed by the management
module as shown in this example.
Brocade# show cpu
... Usage average for all tasks in the last 1 seconds ...
==========================================================
Name us/sec %
idle 755423 100
monitor 13 0
wd 46 0
flash 0 0
dbg 6 0
boot 92 0
main 0 0
itc 0 0
tmr 588 0
ip_rx 211 0
scp 36 0
console 54 0
vlan 0 0
mac_mgr 38 0
mrp 0 0
vsrp 0 0
snms 71 0
rtm 640 0
rtm6 40 0
ip_tx 2478 0
rip 0 0
mpls 119 0
nht 0 0
mpls_glue 13 0
bgp 0 0
bgp_io 0 0
ospf 737 0
ospf_r_calc 0 0
isis 38 0
isis_spf 0 0
mcast 18 0
msdp 134 0
vrrp 0 0
ripng 0 0
ospf6 66 0
ospf6_rt 0 0
mcast6 7 0
bfd 0 0
l4 98 0
stp 0 0
gvrp_mgr 0 0
snmp 0 0